Cutting Board- Design Tech Project
What is your project? For this project, we made a Cutting board
How did you make it? We first started planning on what design we wanted to do. Then we started measuring the dimensions of the wood. we had an option of choosing three different types of wood. i decided to use cherry and walnut wood. we cut the pieces into the length and width we wanted and glued them together. once the glue was dried we cut the board in half then we ran the wood through the thickness planer several times. after we used the table router to make the edges even. we sanded the board and applied varnish oil i let it dry and i put a second layer. and then it was all done.
What do you like most about your project? i liked how the design turned out
What was challenging about this project? the most challenging part was using the wood cutter. i found it difficult to use
What would you change about the project if you did it again? i would make a more complex design next time
What is your plan for it now that it's done? im going to use it as a cutting board
Comments
Post a Comment